Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
6.1.22 vlan pvid
This command changes the VLAN ID per interface. When an untagged packet comes to
the switch, it will be tagged with the PVID value as the VLAN ID for further processing.
By default, every port belongs to VLAN 1 and the PVID value is set to 1.
Default
Format
Mode
6.1.22.1 no vlan pvid
This command sets the VLAN ID per interface to 1.
Format
Mode
6.1.23 vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to
enabled. If tagging is enabled, traffic is transmitted as tagged frames. If tagging is
disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification
number.
Format
Mode
6.1.23.1 no vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to
disabled. If tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid
VLAN identification number.
Format
Mode
VLAN Commands
1
vlan pvid <1-4094>
Interface Config
no vlan pvid
Interface Config
vlan tagging <1-4094>
Interface Config
no vlan tagging <1-4094>
Interface Config
v3.0, January 2008
6-11