Access-List - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

13.8.1 access-list

This command creates an IP Access Control List (ACL) that is identified by the ACL
number
.
The IP ACL number is an integer from 1 to 99 for an IP standard ACL and from 100 to
199 for an IP extended ACL.
The IP ACL rule is specified with either a permit or deny action.
The protocol to filter for an IP ACL rule is specified by giving the protocol to be used like
icmp,igmp,ip,tcp,udp.
The command specifies a source IP address and source mask for match condition of the IP
ACL rule specified by the srcip and srcmask parameters.
The source layer 4 port match condition for the IP ACL rule is specified by the port value
parameter. The range of values is from 0 to 65535.
The <
portvalue>
of
domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp
of these values translates into its equivalent port number, which is used as both the start
and end of a port range.
The command specifies a destination IP address and destination mask for match condition
of the IP ACL rule specified by the dstip and dstmask parameters.
The command specifies the TOS for an IP ACL rule depending on a match of precedence
or DSCP values using the parameters dscp,
The command specifies the assign-queue which is the queue identifier to which packets
matching this rule are assigned.
Default
IP Standard ACL:
Format
Mode
Quality of Service (QoS) Commands
parameter uses a single keyword notation and currently has the values
none
access-list <1-99> {deny | permit} {every | <srcip>
<srcmask>} [assign-queue <queue-id>]
Global Config
v3.0, January 2008
, tos/tosmask.
precedence
, and . Each
www
13-37