Match Ip Tos - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

13.3.12 match ip tos

This command adds to the specified class definition a match condition based on the value
of the IP TOS field in a packet, which is defined as all eight bits of the Service Type octet
in the IP header. The value of
The value of
<tosmask>
denotes the bit positions in
field in a packet. For example, to check for an IP TOS value having bits 7 and 5 set and bit
1 clear, where bit 7 is most significant, use a
of a2 (hex).
<tosmask>
Note: The ip dscp, ip precedence, and ip tos match conditions are alternative
Note: This "free form" version of the IP DSCP/Precedence/TOS match
Format
Mode
Quality of Service (QoS) Commands
<tosbits>
is a two-digit hexadecimal number from 00 to ff. The
<tosbits>
ways to specify a match criterion for the same Service Type field in the IP
header, but with a slightly different user notation.
specification gives the user complete control when specifying which bits of
the IP Service Type field are checked.
match ip tos <tosbits> <tosmask>
Class-Map Config
v3.0, January 2008
is a two-digit hexadecimal number from 00 to ff.
that are used for comparison against the IP TOS
value of a0 (hex) and a
<tosbits>
<tosmask>
13-15