Spanning-Tree Forceversion; Spanning-Tree Forward-Time - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
5.1.6.1 no spanning-tree edgeport all
This command disables Edge Port mode for all ports within the common and internal
spanning tree.
Format
Mode

5.1.7 spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value. The Force
Protocol Version can be one of the following:
• 802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d
functionality supported)
• 802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w
functionality supported)
• 802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Default
Format
Mode
5.1.7.1 no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value, i.e. 802.1s.
Format
Mode

5.1.8 spanning-tree forward-time

This command sets the Bridge Forward Delay parameter to a new value for the common
and internal spanning tree. The forward-time value is in seconds within a range of 4 to 30,
with the value being greater than or equal to "(Bridge Max Age / 2) + 1".
Default
Format
Mode
5-4
spanning-tree edgeport all
Global Config
802.1s
spanning-tree forceversion <802.1d | 802.1w |
802.1s>
Global Config
no spanning-tree forceversion
Global Config
15
spanning-tree forward-time <4-30>
Global Config
v3.0, January 2008
Spanning Tree Protocol Commands