Radius Server Key - NETGEAR ProSafe GSM7228PS Cli Manual

(Switch) (Config) #radius server host auth 192.168.37.60 name
Network1_RADIUS_Auth_Server port 1813
(Switch) (Config) #radius server host acct 192.168.37.60 name
Network2_RADIUS_Auth_Server
(Switch) (Config) #no radius server host acct 192.168.37.60

radius server key

This command configures the key to be used in RADIUS client communication with the specified
server. Depending on whether the 'auth' or 'acct' token is used, the shared secret is configured for
the RADIUS authentication or RADIUS accounting server. The IP address or hostname provided
must match a previously configured server. When this command is executed, the secret is
prompted.
Text-based configuration supports Radius server's secrets in encrypted and non-encrypted format.
When you save the configuration, these secret keys are stored in encrypted format only. If you
want to enter the key in encrypted format, enter the key along with the encrypted keyword. In the
show running config command's display, these secret keys are displayed in encrypted format. You
cannot show these keys in plain text format.
Note: The secret must be an alphanumeric value not exceeding 16 characters.
Format
radius server key {auth | acct} {<ipaddr|dnsname>} encrypted
<password>
Mode Global Config
Field Description
ipaddr The IP address of the server.
dnsname The DNS name of the server.
password The password in encrypted format.
The following shows an example of the CLI command.
radius server key acct 10.240.4.10 encrypted <encrypt-string>
Management Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
8-56