NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual page 105

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Bridge Priority
Bridge Identifier
Time Since
Topology
Change
Topology Change
Count
Topology
Change
Designated Root
Root Path Cost
Root Port
Identifier
Root Port Max
Age
Root Port Bridge
Forward Delay
Hello Time
Bridge Hold Time
Bridge Max Hops
CST Regional
Root
Regional Root
Path Cost
Spanning Tree Protocol Commands
Specifies the bridge priority for the Common and Internal
Spanning tree (CST). The value lies between 0 and 61440. It
is displayed in multiples of 4096.
The bridge identifier for the CST. It is made up using the
bridge priority and the base MAC address of the bridge.
Time in seconds.
Number of times changed.
Boolean value of the Topology Change parameter for the
switch indicating if a topology change is in progress on any
port assigned to the common and internal spanning tree.
The bridge identifier of the root bridge. It is made up from the
bridge priority and the base MAC address of the bridge.
Value of the Root Path Cost parameter for the common and
internal spanning tree.
Identifier of the port to access the Designated Root for the
CST.
Derived value.
Derived value.
Configured value of the parameter for the CST.
Minimum time between transmission of Configuration
Bridge Protocol Data Units (BPDUs)
Bridge max-hops count for the device.
Bridge Identifier of the CST Regional Root. It is made up
using the bridge priority and the base MAC address of the
bridge.
Path Cost to the CST Regional Root.
v3.0, January 2008
5-11