Poe; Poe Priority; Poe Limit - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

16.1.1 poe

This command enables or disables the Power over Ethernet function on the specified
port(s).
Default
Format
Mode

16.1.2 poe priority

This command sets the priority level for the delivery of power to an attached device. The
switch may not be able to supply power to all connected devices, so the port priority is
used to determine which ports will supply power if adequate power capacity is not
available for all enabled ports. For ports that have the same priority level, the lower
numbered port will have higher priority.
Default
Format
Mode

16.1.3 poe limit

This command sets the power limit (in watts) for the port. The port will not supply more
power than the value specified as the limit.
For the FSM7352PS amd FSM7328PS, the valid range is 3 - 18.
Default
Format
Mode
Power Over Ethernet Commands
enable
poe
Global Config
low
poe priority <high/medium/low>
Global Config
18
poe limit
Global Config
v3.0, January 2008
16-3