Managing Permanent Mac Address Bindings - NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual
Web/email security threat management appliance
Hide thumbs
Also See for STM150 - ProSecure Web And Email Threat Management Appliance:
- Installation manual (2 pages) ,
- Appliance reference manual (248 pages) ,
- Reference manual (95 pages)
Table of Contents
Advertisement
ProSecure Web/Email Security Threat Management (STM) Appliance
3.
Select the check boxes and radio buttons and make your selections from the drop-down list
as explained in the following table:
Table 15. Network Refresh Settings
Setting
Automatically Refresh the Network
Periodically
refresh the MAC
address
bindings
Click Apply to schedule the automatic refresh of the network, or click Reset to return to the default settings.
Manually Refresh the Network
Click Refresh to immediately refresh the network.
Note:
When you click Refresh, the network restarts.
Note:
The Advanced Settings button is described in the following section.
Managing Permanent MAC Address Bindings
You can permanently bind a MAC address to an interface. Such a binding does not change
when the network topology changes and does not need to be redetected by the STM.
To create a permanent MAC binding:
1.
Select Global Settings > Network Settings from the menu. The Network Settings
submenu tabs display with the Network Settings screen in view.
2.
Click the Network Refresh submenu tab. The Network Refresh screen displays (see the
previous figure, which shows the STM150). Locate the Manually Refresh the Network
section.
3.
Click the Advanced Settings button. The screen expands to display the MAC Address
Bindings section.
Description (or Subfield and Description)
Select this check box to enable the periodic refresh of the dynamic MAC address
bindings. Specify if the refresh occurs either weekly or daily.
Weekly
Select the Weekly radio button to enable a weekly refresh of the network,
and then specify when the refresh needs to occur by selecting the day,
hour, and minutes from the drop-down lists.
Daily
Select the Daily radio button to enable a daily refresh of the network, and
then specify when the refresh needs to occur by selecting the hour and
minutes from the drop-down lists.
Chapter 3. Performing Network and System Management
| 59
Advertisement
Table of Contents
Troubleshooting
