NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual page 16

Table 2. LED Descriptions for the STM150 (Continued)
Object Activity
Right LED Off
On (amber)
On (green)
Front Panel STM300
The following figure shows the front panel ports and LEDs of the STM300:
1) Console port
Figure 3.
From left to right, the STM300's front panel shows the following ports and LEDs:
1. Console port. Port for connecting to an optional console terminal. The port has a DB9
male connector. The default baud rate is 9600 K. The pinouts are (2) Tx, (3) Rx, (5) and
(7) Gnd.
2. Power LED.
3. Status LED.
4. Hard drive (HDD) LED.
5. One nonfunctioning USB port. This port is included for future management enhancements.
The port is currently not operable on any STM model.
6. Dedicated management (Mgmt) Gigabit Ethernet port with an RJ-45 connector.
7. One uplink (WAN) Gigabit Ethernet port with an RJ-45 connector, left LED, and right LED.
8. One downlink (LAN) Gigabit Ethernet port with RJ-45 connectors, left LED, and right LED.
Note: All Gigabit Ethernet ports provide switched N-way, automatic
speed-negotiating, auto MDI/MDIX technology.
16 | Chapter 1. Introduction
ProSecure Web/Email Security Threat Management (STM) Appliance
Description
The LAN port is operating at 10 Mbps.
The LAN port is operating at 100 Mbps.
The LAN port is operating at 1000 Mbps.
2) Power LED
6) Mgmt port
3) Status LED
5) USB port
4) HDD LED
7) Uplink LEDs
8) Downlink LEDs
8) Downlink port
7) Uplink port