NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual page 131

ProSecure Web/Email Security Threat Management (STM) Appliance
To configure scanning exclusion rules:
1. Select Global Settings > Scanning Exclusions from the menu. The Scanning
Exclusions screen displays. This screen shows the Scanning Exclusions table, which is
empty if you have not specified any exclusions. (The following figure shows one
exclusion rule in the table as an example.)
Figure 73.
2. In the Scanning Exclusions section of the screen, specify an exclusion rule as explained in
the following table:
Table 39. Add Scanning Exclusion Settings
Setting
Client IP
Destination IP
Port
Brief Description A description of the exclusion rule for identification and management purposes.
3. In the Add column, click the Add table button to add the exclusion rule to the Scanning
Exclusions table. The new exclusion rule is enabled by default.
To disable a rule, select the check box in the Enable column for the rule.
To delete an exclusion rule from the Scanning Exclusions table, click the Delete table button
in the Action column to the right of the rule that you want to delete.
Description
The client IP address and optional subnet mask that are excluded from all scanning.
The destination IP address and optional subnet mask that are excluded from all
scanning.
The number of the port that is excluded from all scanning.
Chapter 4. Content Filtering and Optimizing Scans | 131