NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual page 18

Front Panel STM600
The following figure shows the front panel ports and LEDs of the STM600:
1) Console port
Figure 4.
From left to right, the STM600's front panel shows the following ports and LEDs:
1. Console port. Port for connecting to an optional console terminal. The ports has a DB9
male connector. The default baud rate is 9600 K. The pinouts are (2) Tx, (3) Rx, (5) and
(7) Gnd.
2. Power LED.
3. Status LED.
4. Hard drive (HDD) LED.
5. One nonfunctioning USB port. This port is included for future management enhancements.
The port is currently not operable on any STM model.
6. Dedicated management (Mgmt) Gigabit Ethernet port with an RJ-45 connector.
7. Pair 1 uplink (WAN) and downlink (LAN) Gigabit Ethernet ports with RJ-45 connectors, left
LEDs, and right LEDs.
8. Pair 2 uplink (WAN) and downlink (LAN) Gigabit Ethernet ports with RJ-45 connectors, left
LEDs, and right LEDs.
Note: All Gigabit Ethernet ports provide switched N-way, automatic
speed-negotiating, auto MDI/MDIX technology.
18 | Chapter 1. Introduction
ProSecure Web/Email Security Threat Management (STM) Appliance
2) Power LED
3) Status LED 6) Mgmt port
5) USB port
4) HDD LED
7) Pair 1 LEDs
8) Pair 2 LEDs
8) Pair 2 ports
7) Pair 1 ports