Setup Wizard Step 1 Of 10: Introduction; Setup Wizard Step 2 Of 11: Networking Settings - NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual

ProSecure Web/Email Security Threat Management (STM) Appliance

Setup Wizard Step 1 of 10: Introduction

Figure 20.
The first Setup Wizard screen is just an introductory screen. Click Next to go to the following
screen.

Setup Wizard Step 2 of 11: Networking Settings

Figure 21.
Enter the settings as explained in the following table, and then click Next to go the following
screen.
Note: After you have completed the steps in the Setup Wizard, you can
make changes to the network settings by selecting Global Settings
> Network Settings. For more information about these network
settings, see Configuring Network Settings
Chapter 2. Using the Setup Wizard to Provision the STM in Your Network
on page 52.
| 33