Qualified Web Browsers; Logging In To The Stm - NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual

4. Verify the installation. See
5. Register the STM. See
Each of these tasks is described separately in this chapter.

Qualified Web Browsers

To configure the STM, you need to use a Web browser such as Microsoft Internet Explorer
5.1 or later, Mozilla Firefox l.x or later, or Apple Safari 1.2 or later with JavaScript, cookies,
and SSL enabled.
Although these Web browsers are qualified for use with the STM's Web Management
Interface, SSL VPN users should choose a browser that supports JavaScript, Java, cookies,
SSL, and ActiveX to take advantage of the full suite of applications. Note that Java is required
only for the SSL VPN portal, not for the Web Management Interface.

Logging In to the STM

To connect to the STM, your computer needs to be configured to obtain an IP address
automatically from the STM via DHCP. For instructions on how to configure your computer for
DHCP, see the document that you can access from
To connect and log in to the STM:
1. Start any of the qualified browsers, as explained in
page.
2. Enter https://192.168.1.201 in the address field.
https://192.168.1.201
Figure 14.
Note: The STM factory default IP address is 192.168.1.201. If you change
the IP address, you need to use the IP address that you assigned to
the STM to log in to the STM.
The NETGEAR Configuration Manager Login screen displays in the browser (see the
following figure, which shows the STM300).
28 | Chapter 2. Using the Setup Wizard to Provision the STM in Your Network
ProSecure Web/Email Security Threat Management (STM) Appliance
Verifying Correct Installation
Registering the STM with NETGEAR
on page 49.
on page 50.
Preparing Your Network
Qualified Web Browsers
in Appendix C.
on this