NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual page 41

ProSecure Web/Email Security Threat Management (STM) Appliance
Table 8. Setup Wizard Step 5: Web Security Settings (Continued)
Setting Description (or Subfield and Description)
HTTPS From the HTTPS drop-down list, specify one of the following actions to be taken when an infected
Web file or object is detected:
• Quarantine file. The Web file or object is removed and placed in the malware quarantine for
further research. In addition, a malware quarantine log entry is created, and depending on the
nature of the malware threat, also a virus log entry or spyware log entry.
• Delete file. This is the default setting. The Web file or object is deleted, and a virus log entry or
spyware log entry is created.
• Log only. Only a virus log entry or spyware log entry is created. The Web file or object is not
deleted.
Select the Streaming check box to enable streaming of partially downloaded and scanned HTTPS
file parts to the end user. This method allows the user to experience more transparent Web
downloading. Streaming is enabled by default.
FTP From the FTP drop-down list, specify one of the following actions to be taken when an infected Web
file or object is detected:
• Quarantine file. The Web file or object is removed and placed in the malware quarantine for
further research. In addition, a malware quarantine log entry is created, and depending on the
nature of the malware threat, also a virus log entry or spyware log entry.
• Delete file. This is the default setting. The Web file or object is deleted, and a virus log entry or
spyware log entry is created.
• Log only. Only a virus log entry or spyware log entry is created. The Web file or object is not
deleted.
Scan Exceptions
From the drop-down list, specify one of the following actions to be taken when a Web file or object exceeds the
size that you specify in the file size field:
• Skip. The file is not scanned but skipped, leaving the end user vulnerable. This is the default setting.
• Block. The file is blocked and does not reach the end user.
The default and maximum file sizes are as follows:
• For the STM600 and STM300, the default setting is to block any attachment larger than 10240 KB. The
maximum file size that you can specify is 51200 KB.
• For the STM150, the default setting is to block any attachment larger than 8192 KB. The maximum file size
that you can specify is 25600 KB.
Note: Setting the maximum file size to a high value might affect the STM's performance. NETGEAR
recommends the default value, which is sufficient to detect the vast majority of threats.
Chapter 2. Using the Setup Wizard to Provision the STM in Your Network | 41