Configuring The Http Proxy Settings - NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual

4. Complete the fields and make your selections from the drop-down lists as explained in the
following table:
Table 16. MAC Address Binding Settings
Setting
MAC Address
Port (STM150) or Interface
(STM300 and STM600)
Type
5. To add the newly configured MAC address binding to the MAC Address Bindings table, click
the Add table button in the Action column.
The MAC Address Bindings table displays both the dynamic bindings that are automatically
detected by the STM and the permanent bindings that you have created.
Changing a Dynamic MAC Address Binding to a Permanent Binding
To change a dynamic binding to a permanent binding:
1. Locate the dynamic MAC address binding that you want bind permanently, and select an
interface from the Port drop-down list (STM150) or Interface drop-down list (STM300
and STM600).
2. Click the corresponding Add table button in the Action column.
Activating, Editing, or Deleting a Permanent MAC Address Binding
For each permanent binding in the MAC Address Bindings table, the Action column provides
two table buttons:
• Apply. Activates the permanent MAC address binding.
• Delete. Deletes the permanent MAC address binding from the table.
To assign another interface to a permanent MAC address binding:
1. Locate the dynamic MAC address binding that you want to edit, and select another
interface from the Port drop-down list (STM150) or Interface drop-down list (STM300
and STM600).
2. Click Apply to save your changes.

Configuring the HTTP Proxy Settings

If you have used the Setup Wizard, you might have already configured an HTTP proxy; the
HTTP Proxy screen allows you to modify these settings. If the STM is installed behind an
HTTP proxy, you might need to specify the HTTP proxy settings for the STM to connect to the
60 | Chapter 3. Performing Network and System Management
ProSecure Web/Email Security Threat Management (STM) Appliance
Description
Enter the MAC address that you want to bind permanently.
From the drop-down list, select the interface to which the MAC address needs
to be bound.
This field is automatically determined: it displays Permanent or Dynamic.