ProSecure Web/Email Security Threat Management (STM) Appliance
3.
In the Registration Key field, enter the license key.
4.
Fill out the customer and VAR fields.
5.
Click Register.
6.
Repeat
step 3
and
The STM activates the licenses and registers the unit with the NETGEAR registration server.
Note:
If you reset the STM to the original factory default settings after you
have entered the license keys to activate the STM (see
the STM with NETGEAR
The license keys and the different types of licenses that are
available for the STM are no longer displayed on the Registration
screen. However, after you have reconfigured the STM to connect to
the Internet and to the NETGEAR registration server, the STM
retrieves and restores all registration information based on its MAC
address and hardware serial number. You do not need to reenter the
license keys or reactivate the STM.
What to Do Next
You have completed setting up and deploying the STM to the network. The STM is now set
up to scan the protocols and services that you specified for malware threats and to perform
updates based on the configured update source and frequency.
If you need to change the settings, or to view reports or logs, log in to the STM Web
Management Interface, using the default IP address or the IP address that you assigned to
the STM in
Setup Wizard Step 1 of 10: Introduction
The STM is ready for use. However, the following sections describe some important tasks
that you might want to address before you deploy the STM in your network:
•
Changing Administrative Passwords and Timeouts
•
Managing Digital Certificates
•
Configuring Groups
•
Configuring User Accounts
•
Configuring Authentication
•
Setting Scanning Exclusions and Web Access Exceptions
step 5
for additional license keys.
on page 50), the license keys are erased.
on page 76
on page 148
on page 152
on page 154
Chapter 2. Using the Setup Wizard to Provision the STM in Your Network
Registering
on page 33.
on page 62
on page 130
| 51