NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual page 40

Note: After you have completed the steps in the Setup Wizard, you can
make changes to the Web security settings by selecting Web
Security > Policy or Web Security > HTTP/HTTPS > Malware
Scan. The Malware Scan screen also lets you specify HTML
scanning and notification settings. For more information about these
settings, see
Table 8. Setup Wizard Step 5: Web Security Settings
Setting Description (or Subfield and Description)
Services to Scan
HTTP HTTP scanning is enabled by
default on standard service port 80.
HTTPS HTTPS scanning is disabled by
default.
FTP FTP scanning is enabled by default
on standard service port 21.
Scan Action
HTTP From the HTTP drop-down list, specify one of the following actions to be taken when an infected
Web file or object is detected:
• Quarantine file. The Web file or object is removed and placed in the malware quarantine for
further research. In addition, a malware quarantine log entry is created, and depending on the
nature of the malware threat, also a virus log entry or spyware log entry.
• Delete file. This is the default setting. The Web file or object is deleted, and a virus log entry or
spyware log entry is created.
• Log only. Only a virus log entry or spyware log entry is created. The Web file or object is not
deleted.
Select the Streaming check box to enable streaming of partially downloaded and scanned HTTP
file parts to the end user. This method allows the user to experience more transparent Web
downloading. Streaming is enabled by default.
40 | Chapter 2. Using the Setup Wizard to Provision the STM in Your Network
ProSecure Web/Email Security Threat Management (STM) Appliance
Configuring Web and Services Protection
To disable Hypertext Transfer Protocol (HTTP) scanning,
clear the corresponding check box. You can change the
standard service port or add another port in the
corresponding Ports to Scan field.
To enable Hypertext Transfer Protocol over Secure Socket
Layer (HTTPS) scanning, select the corresponding check
box. You can change the standard service port (number 443)
or add another port in the corresponding Ports to Scan field.
To disable File Transfer Protocol (FTP) scanning, clear the
corresponding check box. You can change the standard
service port or add another port in the corresponding Ports to
Scan field.
on page 105.