Rear Panel Features - NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual

Rear Panel Features

The rear panel of the STM150 differs from the rear panels of the STM300 and STM600.
Rear Panel STM150
The following figure shows the rear panel components of the STM150:
1) Console port
Figure 5.
From left to right, the STM150's rear panel components are:
1. Console port. Port for connecting to an optional console terminal. The port has a DB9
male connector. The default baud rate is 9600 K. The pinouts are (2) Tx, (3) Rx, (5) and
(7) Gnd.
2. Kensington lock. Attach an optional Kensington lock to prevent unauthorized removal of the
STM150.
3. Power button. Press to restart the STM150. Restarting does not reset the STM150 to its
factory defaults.
4. Reset button. Using a sharp object, press and hold this button for about 10 seconds until the
front panel Test LED flashes and the STM150 returns to factory default settings.
Note: If you reset the STM150, all configuration settings are lost and the
default passwords are restored.
5. AC power socket. Attach the power cord to this socket.
20 | Chapter 1. Introduction
ProSecure Web/Email Security Threat Management (STM) Appliance
4) Reset button
2) Lock
3) Power button
5) AC power socket