Table of Contents
Advertisement
Mounting OmniSwitch 6450 Switches
Rack Mounting Steps
Attach rack mount brackets to both sides of the chassis as shown.
1
Mark the holes on the rack where the switch is to be installed.
2
Lift and position the switch until the rack-mount brackets are flush with the rack post, then align the
3
holes in the brackets with the rack holes that were marked at step 1.
Once the holes are aligned, insert a rack mount screw (not provided) through the bottom hole of each
4
bracket. Tighten both screws until they are secure.
.
Note
Be sure to install the screws in the bottom hole of each bracket, as shown, before proceeding.
OmniSwitch 6450 Hardware Users Guide
Rack-Mounting 24 and 48-Port OS6450 Switches
January 2015
page 3-11
Advertisement
Table of Contents
