Table of Contents
Advertisement
Starting Up and Exiting the Support Tool
2-1
Starting Up and Exiting the Support Tool
2-1-1
Start-Up Procedure
Procedure 1. Switch on the power supply to the personal computer to start up DOS.
Reference: When the support tool is started up for the first time, the "Tool Settings" screen is
8
This section describes the procedure for starting up the support tool once it has
been installed in a personal computer.
The method for start-up differs a little according to the hard disk drive and directory
in which the support tool is installed.
Check that the current drive is the drive for the hard disk in which the support
tool is installed.
If it is not, enter "C:
(C:), specify the drive name of the drive in which the support tool is installed.
2. Use the command "CD \NT
ry that contains the support tool. For the underlined part (\NT), specify the
name of the directory into which the support tool was copied.
3. Input "NT
".
The support tool will start up.
S "Main Menu" screen of the support tool
When the support tool starts up the "Main Menu" screen shown below will be
displayed.
displayed first. See 3-3 "Tool Settings" Screen (p.22).
" to change the current drive. For the underlined part
" to change the current directory to the directo-
Section 2-1
Advertisement
Table of Contents
