Table of Contents
Advertisement
Inputting Image and Library Data
4-11
Inputting Image and Library Data
Caution: S To modify an image or library data that is already being used for display, either
Reference: When using an NT30C or NT610C, if an image is displayed in the two-color mode,
This section describes how to display image and library data created on the
"Screen Selection" screen.
Images can only be used with the NT30, NT30C, NT612G, and NT610C. The
codes that can be used are FE20 to FEFF (224 codes).
Library data can only be used when using an NT30, NT30C, NT612G, or NT610C
with Ver.2 or a later version of the direct connection function.
The codes that can be used for library data are listed below:
Ver.3 and later: FA20 to FAFF, FB20 to FBFF, FC20 to FCFF, FD20 to FDFF
(896 codes)
S Displaying Images and Library Data
Images can be displayed in one of two ways: by specifying a code during charac-
ter input, or by making a selection from the fixed display menu (library data can
only be selected by making a selection from the fixed display menu).
Images and library data can also be specified for display when an "image & li-
brary lamp" goes OFF or comes ON (see p.102).
Setting "Yes" for "Brkn Line Frame Disp" in the environmental settings (tool set-
tings for the "Edit" screen) will enable you to check the image/library data regis-
tration range on the screen at any time.
If "Hspeed" is set for "Disp Mode" in the environmental settings (tool settings for
the "Edit" screen), only the broken line frame will be displayed, without the
image/library data.
re-edit the registered data by using the "Image & Lib" option on the "Screen
Selection" screen, or delete it and then redisplay it. However, note that when the
registered data is modified, the data identified by the relevant code is changed
for all screens that use that code.
S If an attempt is made to display the codes of image and library data for which no
data is registered,
the display color and background color can be specified.
(1) Specification during character input
Pressing the [F4] (Image) key when inputting characters or a label enables
selection of an image from the image selection screen.
It is possible to use images in combination with characters and marks.
marks will be displayed.
Section 4-11
141
Advertisement
Table of Contents
