Table of Contents
Advertisement
"Scr list" Screen
information of
data to be read
*1
Screen data
Reading source
screen information
Mark data
All/part?
Reading source
range information
(start point, end point)
Numeral table
Character-string table
Direct connection information
I/O comment
Bit memory table
Read execution
confirmation
Image data
Library data
All/part?
Reading source
code information
(3) The procedure after this point differs according to the type of data: see the
scheme below. Specify the data to be read, the reading source and reading
destination by following the directions on the screen in order to read the data.
Reading destination
screen information
*2
*2
All
Read execution
confirmation
Part
Read position
information
Execution of reading
*4
All
Read execution
confirmation
Part
Reading destination
code information
*5
*5
(*1)
The following restrictions apply to the data that can be read.
Image data: "30", "30C", "610G", and "610C" only.
Library data: "30", "30C", "610G", and "610C", Ver.3 or later only.
Direct connection information:
I/O comment:
Bit memory table:
(*2)
When the [Tab] key is pressed and a screen number input, the bar cursor
shifts to the specified screen.
(*3)
Overwrite:
Insert:
Overwrite/insert
information
*3
Execution of reading
Read execution
confirmation
Execution of reading
Confirmation of
reading execution
When direct connection used only.
When direct connection used only
"30", "30C", "610G", and "610C", Ver.3 or later only.
If data already exists at the destination it is overwritten (the
original data is cleared).
If data already exists at the destination the data is read into the
file without clearing the original data.
Section 3-5
Read execution
Execution of reading
confirmation
Execution of reading
Execution of reading
37
Advertisement
Table of Contents
