Table of Contents
Advertisement
Receiving Data
Receiving Data in Screen Units
Procedure 1. Set the PT to the "Transmit Mode"
Whether or not it is possible to execute data reception in screen units depends on
the PT model. For details, see "Types of Data Communication with Each PT Mod-
el" (p.185).
2. Display the "Screen Selection" screen.
It does not matter where the bar cursor is.
3. Press the [F10] (Next) key, then press the [F7] (Rcv.) key.
4. Specify "Screen Data" or "Memory Table" as the type of data to be received,
then press the
key.
5. Specify the screen number at the PT side and the screen number at the sup-
port tool side, pressing the
6. A message will displayed for the purpose of confirmation.
Check the message and press the
Press the [Esc] key to abort reception.
"
7. Reception will start.
On completion of reception, the message "Data successfully transmitted" will
be displayed.
Press the [Esc] key to stop reception part way through.
"
key after each specification.
key.
Section 7-3
191
Advertisement
Table of Contents
