Table of Contents
Advertisement
Basic Operating Procedures
2-2-6
Selecting Numbers and Codes
16
The support tool allows simple selection of the following numbers and codes.
S Screen numbers
S Numeral table numbers
S Character-string memory table numbers
S Bit memory table numbers
S Image codes
S Library codes
S Extended I/O input terminal numbers (*)
S Extended I/O output terminal numbers (*)
(*)
Only number specification using the [Tab] key can be used for these.
When a screen that displays a list of numbers or codes is displayed, the key opera-
tions indicated below can be used:
[Shift] + [ ] key
: Moves the bar cursor from the position where it is currently
located to the previous number or code for which there is
data.
[Shift] + [ ] key
: Moves the bar cursor from the position where it is currently
located to the next number or code for which there is data.
Example:
Assume that the bar cursor is on screen number 6 and there is data only for screen
numbers 2, 4, and 10:
[Shift] + [ ] key
: The bar cursor moves to screen number 4.
[Shift] + [ ] key
: The bar cursor moves to screen number 10.
If now, while the bar cursor is at screen number 10, [Shift] + [ ] is pressed again,
the bar cursor will move full cycle to screen number 2.
Section 2-2
Advertisement
Table of Contents
