Table of Contents
Advertisement
Setting Lamps
Setting Image/Library Lamps (NT30, NT30C, NT612G, NT610C, with Ver.2 Direct Connection Only)
Procedure 1. Select "LAMP" on the initial editing screen.
Reference: To "increment copy" an existing entry into the next input field (incrementing the bit
102
7. A box indicating the size of the label will be displayed in the center of the lamp
graphic.
Move this box to the required display position and press the
If "No" is set for the "Label" setting in the "Lamp Setting" window, it will not be
possible to make this setting.
8. The specified label and lamp graphic will be displayed.
9. The screen on which registration fields for lamps can be selected will be dis-
played.
To create another lamp, select a field.
To quit lamp creation, press the [Esc] key.
This is the procedure for setting image/library lamps, which display different image
data or library data according to the status of a PC bit.
When using an NT20S, NT20M, NT600S, or NT600M, when using an NT612G or
NT610C and not using direct connection, or when using Ver.1 direct connection,
this setting is not possible.
2. Select the field for lamp registration in the window and press the
To delete an existing lamp from the field in which it is registered, locate the cur-
"
sor at that field and press the [F1] (Delete) key.
number), press the [F2] (iCopy) key with the cursor located in the "Bit" column at
that entry (see p.77).
3. Select "Image & Lib" as the lamp type and press the
Section 4-6
key.
key.
key.
Advertisement
Table of Contents
