Table of Contents
Advertisement
Creating Fixed Displays
Deleting Circles/Arcs
Procedure 1. Select "CIRC/ARC" from the fixed display menu and then press the [F1] (De-
Modifying Circles/Arcs
Procedure 1. Select "CIRC/ARC" from the fixed display menu, then press the [F2] (Modify)
lete) key.
A j mark will be displayed at the start point of the circle/arc.
2. Locate the cursor at the j mark of the circle/arc to be deleted and press the
key.
3. Check the message and then press the
To abort deletion, press the [Esc] key.
key.
A j mark will be displayed at the start point of the circle/arc.
It is also possible to proceed straight to step 3. by left clicking on the circle or
arc to be modified (see p.57).
2. Locate the cursor at the j mark of the circle/arc to be modified and press the
key.
3. Select the required item and execute the modification.
S Attribute:
Select to change the display attribute. This selection is only
valid if using an NT30, NT30C, NT612G, or NT610C.
S Color:
If using an NT30C or NT610C, select to change the line
color.
S Display position:
Select to move the end point of an arc.
Pressing the [Esc] key makes it possible to change the start
point and center point also.
After changing the shape, press the
4. Press the [Esc] key to quit modification.
Section 4-3
key; the circle/arc will be deleted.
key.
91
Advertisement
Table of Contents
