Table of Contents
Advertisement
Preparation and Procedure for Data Communication with the PT
Communication Speed
Reference: Presented below are OMRON's measurements of the time taken to transfer the
Tool Settings When Communicating With an NT20S or NT600S
Tool Settings
"PT Type"
Setting
20M
20S
20M
20S
20S
Tool Settings
"PT Type"
Setting
600M
600S
600M
600S
600S
186
Select the communication speed for communication with the PT by setting "Com-
munication Mode" on the "Tool Settings" screen.
Setting "Hspeed" for this setting will enable high-speed data transfer.
If the communication environment is unfavorable or communication errors occur,
set "Stndrd" for low-speed communication so that the data will be communicated
reliably.
entire capacity of the image memory when transfer is in the "Hspeed" mode. Use
these as a guide to data communication times.
S When using a capacity of 512 Kbytes:
S When using a capacity of 1 Mbyte:
Communication in the "Stndrd" mode takes approximately twice as long as com-
munication in the "Hspeed" mode.
When using an NT20S or NT600S, the combination of tool settings that allows
communication with the support tool depends on which model is used.
Set the tool settings for communication with an NT20S or NT600S correctly by re-
ferring to the table below.
S When using an NT20S
Direct Access
Not used
Not used
Ver.4
Ver.4
Ver.5
S When using an NT600S
NT600S-ST121/
Direct Access
Not used
Not used
f in NT600M
Ver.4
Ver.4
Ver.5
NT20S-ST121-V1/
NT20S-ST121
x
x
f in NT20M com-
f
patible mode
x
x
NT600S-ST 121-V1/
ST211-V1 direct
ST211
connection
x
x
f in NT600M
compatible
compatible mode
mode
f
x
5 min. 5 sec.
9 min. 30 sec.
Model
NT20S-ST128
ST122-V1
x
x
f
f
f: possible x: not possible
Model
NT600S-ST121-V1/
ST211-V1 direct
connection
x
x
f
f
f: possible x: not possible
Section 7-1
x
f
x
x
x
x
f
x
x
x
Advertisement
Table of Contents
