Table of Contents
Advertisement
Creating Fixed Displays
4-3-2
Inputting Marks
Displaying Marks
Deleting Marks
Procedure 1. Select "FIX DSP" from the initial editing menu.
82
Created marks are input during screen editing. Marks can be handled in the same
way as characters and magnification scales can be specified for them.
However, smoothing is only possible for 16 x 16 dot marks when using an NT30,
NT30C, NT612G, or NT610C.
Select the mark that you want to display from the mark selection screen.
Marks can be displayed in the following two ways.
(1) Specification during character input
Press the [F3] (Mark) key after inputting characters or a label to display the
mark selection screen. Only 16 x 16 dot marks can be input.
(2) Specification using the fixed editing menu
Select "Mark" from the fixed display menu and specify the display position: the
mark selection screen will be displayed.
This operation cannot be used with the NT20S, NT20M, NT600S, or
NT600M.
Select the mark to be displayed from this screen, specify the Details and char-
acter color if using an NT30C or NT610C, then specify the display position.
32 x 32 and 64 x 64 dot marks can also be displayed at the same time.
The mark will be displayed in its actual form in the character input field. It will
be displayed on the editing screen with its bottom left extremity take as the
origin.
Marks displayed on the screen can be deleted using the following method (marks
located inside character-strings can be deleted using the "STR IN" function).
The fixed display menu will be displayed.
2. Select "MARK".
3. Press the [F1] (Delete) key.
4. Locate the cursor at the mark to be deleted and press the
5. Check the message and then press the
Section 4-3
key.
key.
Advertisement
Table of Contents
