Images
5-2-1
Procedure for Image Creation
Procedure 1. Select "Image & Lib" on the "Screen Selection" screen.
Image data is created on the screen in dot units using mouse and key operations,
then the required area is specified and the image registered. Up to 224 images can
be registered.
2. Locate the cursor at the code (from FE20 to FEFF) of the image to be created
and press the
key.
Use [Shift] + [ ] or [Shift] + [ ] to move the bar cursor to the previous or next
"
code for which there is data.
Use the [ ]/[ ] keys to switch between image and library data.
Press the [Tab] key to display the code input field.
The data of a code for which data already exists can be deleted by pressing the
[F1] (Delete) key and then specifying that code.
The data of a code can be copied by pressing the [F2] (Copy) key and then
specifying the copy source code and the copy destination code.
Existing comments can be changed by pressing the [F6] (Commnt) key and
inputting the required characters.
3. Draw image data on the screen using the mouse and keys (see "Image Editing
Operations" on the next page).
4. Press the [Esc] key to quit image creation.
On quitting, specify "Confirm".
5. Select whether or not to reduce the saved data.
Displaying reduced image data takes more time than displaying image data
"
that is not reduced.
6. Specify the area that is to be saved as the image data.
locate the cross-hair cursor at the start point and end point of the area and
press the
key at each.
7. Input a comment.
This is a memo that indicates the nature of the image data.
Section 5-2
165