Table of Contents
Advertisement
Creating Fixed Displays
4-3-6
Creating Circles/Arcs
Procedure 1. Select "FIX DSP" from the initial editing menu.
90
This is the procedure for drawing circles and arcs.
Arcs cannot be created when using an NT20S, NT20M, NT600S, or NT600M.
The fixed display menu will be displayed.
2. Select "CIRC/ARC" from the fixed display menu.
3. Select the display attribute with "Detail"
The selectable options are "normal", "inverted", "flashing", and "spot".
The selected attribute will be valid only for circles.
When using an NT20S, NT20M, NT600S, or NT600M, the attribute is fixed as
"normal".
4. If using an NT30C or NT610C, specify the line color.
5. Press the
key with the cursor on "Exec".
6. Draw the circular/arc.
1) Press the
key at the center of the circle or arc.
2) Move the cursor to set the size of the circle or arc and press the
3) For a circle:
After setting the size, simply press the
For an arc:
Locate the cursor at the end point of the arc. Specify the direction in which
the arc is to be drawn with the [Insert] key, then press the
Center
7. Press the [Esc] key to quit circle/arc drawing.
End point of the arc
Start point of the arc
(
)
Section 4-3
key once more.
key.
(
)
(
)
key.
Advertisement
Table of Contents
