Table of Contents
Advertisement
Creating Fixed Displays
4-3-7
Creating Fans
Procedure 1. Select "FIX DSP" from the initial editing menu.
Deleting Fans
Procedure 1. Select "FAN" from the fixed display menu and then press the [F1] (Delete) key.
92
This is the procedure for drawing fans.
It cannot be used if using an NT20S, NT20M, NT600S, or NT600M.
The fixed display menu will be displayed.
2. Select "FAN" from the fixed display menu.
3. Select the display attribute with "Detail".
The selectable options are "normal", "inverted", "flashing", and "spot".
4. If using an NT30C or NT610C, specify the line color.
5. Press the
key with the cursor on "Exec"
6. Draw the fan.
1) Press the
key at the center of the fan.
2) Move the cursor to set the size and start point of the fan and press the
key.
3) Locate the cursor at the end point of the fan.
4) Specify the direct in which the fan is to be drawn by using the [Insert] key,
then press the
Center (
)
7. Press the [Esc] key to quit fan drawing.
A j mark will be displayed at the start point of the fan.
2. Locate the cursor at the j mark of the fan to be deleted and press the
3. Check the message and then press the
To abort deletion, press the [Esc] key.
key.
End point (
Start point
(
key; the fan will be deleted.
Section 4-3
)
)
key.
Advertisement
Table of Contents
