Table of Contents
Advertisement
Creating Graphs
Reference: S If a broken line extends beyond the frame, only the part contained by the frame
Setting Broken Line Graphs (NT30, NT30C, NT612G, NT610C with Ver.3 or Later)
Procedure 1. Select "GRAPH" from the initial editing screen.
8. Press the
key with the cursor on "Exec".
9. A box that indicates the size of the percentage display will be displayed.
Move this box to the required display position and press the
If "No" is set for "Display %", this box is not displayed.
10. The specified percentage display and trend graph will be displayed.
11. The screen on which registration fields for trend graphs can be selected will be
displayed.
To create another trend graph, select a field.
Further broken lines can be added by repeating the operation from step 7.
To quit trend graph creation, press the [Esc] key.
will be displayed, as shown below.
S Each time the [Tab] key is pressed, the graph display changes.
No more than one frame for a broken line graph can be created per screen; up to
256 broken lines can be set within this frame. Each broken line can display the
data in up to 512 numeral tables. Broken line graph frames can be set for screen
(maximum of eight) in an overlapping screen but in this case that the total number
of broken lines for the overlapping screen as a whole cannot exceed 256.
The graph menu will be displayed.
2. Select "BRK-LIN GRAPH" from the graph menu.
If there is already a broken line graph (or graphs), the screen for selecting the
"
field in which the broken line graph is to be registered is displayed. Select an
empty field to proceed to step 7.
3. Locate the cursor at the start point for the broken line graph frame and press
the
key.
Broken line graphs are created as rectangular graphics. They can be oriented
either vertically or horizontally.
4. Locate the cursor at the end point of the broken line graph frame and press the
key.
Section 4-8
key.
123
Advertisement
Table of Contents
