Table of Contents
Advertisement
Creating a user-defined hold at the aircraft present position:
1) Press the FPL Key to display the Active Flight Plan Page (MFD) or the Active Flight Plan Window (PFD).
2) Press the MENU Key, highlight 'Hold At Present Position', and press the ENT Key. The HOLD AT window appears
with the course field highlighted.
3) If desired, use the FMS Knobs to edit the entry course, and press the ENT Key.
4) Use the small FMS Knob to select 'INBOUND' or 'OUTBOUND' course direction, and press the ENT Key.
5) Use the small FMS Knob to select 'TIME' or 'DIST' length mode, and press the ENT Key.
6) Use the FMS Knobs to edit the length, and press the ENT Key.
7) Use the small FMS Knob to select 'RIGHT' or 'LEFT' turn direction, and press the ENT Key.
8) Use the FMS Knobs to edit the Expect Further Clearance Time (EFC TIME), and press the ENT Key.
9) Press the ENT Key while 'ACTIVATE?' is highlighted to create an Offroute Direct-to hold waypoint at the aircraft
present position and activate the hold.
Creating a user-defined hold at a direct-to waypoint:
1) Press a Direct-to Key and set up the direct-to waypoint as desired, but select 'HOLD?' instead of 'ACTIVATE?'
when finished (MFD or PFD).
2) Use the FMS Knobs to edit the entry course, and press the ENT Key.
3) Use the small FMS Knob to select 'INBOUND' or 'OUTBOUND' course direction, and press the ENT Key.
4) Use the small FMS Knob to select 'TIME' or 'DIST' length mode, and press the ENT Key.
5) Use the FMS Knobs to edit the length, and press the ENT Key.
6) Use the small FMS Knob to select 'RIGHT' or 'LEFT' turn direction, and press the ENT Key.
7) Use the FMS Knobs to edit the Expect Further Clearance Time (EFC TIME), and press the ENT Key.
8) Press the ENT Key while 'ACTIVATE?' is highlighted to activate the direct-to with the user-defined hold defined
at the direct-to waypoint. (If the direct-to wayoint is part of the active flight plan, the HOLD is inserted into
the active flight plan. If the direct-to waypoint is not part of the active flight plan, an off-route direct-to hold is
created.)
Exiting a user-defined hold inserted into the active flight plan:
Press the SUSP Softkey. The system will provide guidance to follow the holding pattern to the inbound course
and resume automatic waypoint sequencing.
Removing a user-defined hold inserted into the active flight plan:
1) Press the FPL Key to display the Active Flight Plan Page (MFD) or the Active Flight Plan Window (PFD).
2) Press the FMS Knob to activate the cursor (not required on the PFD) and turn the large FMS Knob to highlight
the HOLD waypoint.
3) Press the CLR Key. A 'Remove Holding Pattern?' confirmation window is displayed.
4) Select 'OK' and press the ENT Key. The holding pattern is removed from the active flight plan. Select 'CANCEL'
and press the ENT Key to cancel the removal of the holding pattern.
190-01895-00 Rev. A
Garmin G1000 Pilot's Guide for the Diamond DA62
FLIGHT MANAGEMENT
223
Advertisement
Table of Contents
Troubleshooting
