User Waypoints - Garmin G1000 Diamond DA62 Pilot's Manual

USER WAYPOINTS

The G1000 can create and store up to 1,000 user-defined waypoints. User waypoints can be created from any
map page (except PFD Inset Map, AUX-Trip Planning Page, or Procedure Pages) by selecting a position on the
map using the Joystick, or from the User Waypoint Information Page by referencing a bearing/distance from
an existing waypoint, bearings from two existing waypoints, or latitude and longitude. Once a waypoint has
been created, it can be renamed, deleted, or moved. Temporary user waypoints are erased upon system power
down.
User Wpt Comment
Navigation Map
Showing Selected
User Waypoint
Selected User
Waypoint
Softkeys
Selecting a User Waypoint:
1) With the User Waypoint Information Page displayed, enter the name of the User Waypoint, or scroll to the
desired waypoint in the User Waypoint List using the large FMS Knob.
2) Press the ENT Key.
3) Press the FMS Knob to remove the flashing cursor.
Or :
1) With the Nearest User Waypoints Page displayed, press the FMS Knob.
2) Press the ENT Key or turn either FMS Knob to select an identifier in the Nearest USR Box.
3) Press the FMS Knob to remove the flashing cursor.
190-01895-00 Rev. A
Figure 5-45 User Waypoint Information Page
Garmin G1000 Pilot's Guide for the Diamond DA62
FLIGHT MANAGEMENT
User Waypoint Info
- Identifier
- Temporary/Normal
- Waypoint Type
Reference Wpt/Info
- Identifier/Rad/Dist or
- Identifiers/Radials or
- Region/Lat/Long
User Waypoint List
- Identifier
- Comment
# User Wpts Used
GO BACK displayed if
User Wpt was created
on map page
175