Garmin G1000 Diamond DA62 Pilot's Manual page 380

HAZARD AVOIDANCE
s s
ectoR can
1) While in horizontal scan mode, press the BRG Softkey to display the Bearing Line and place the cursor in the
BEARING field. If the Bearing Line is not displayed, press the MENU Key and turn the large FMS Knob to select
Show Bearing Line.
2) Press the ENT Key.
3) Turn the small FMS Knob to place the Bearing Line in the desired position. The location of the Bearing Line
becomes the center point of the Sector Scan.
4) Turn the large FMS Knob to place the cursor in the SECTOR SCAN field.
5) Turn the small FMS Knob to select FULL, 60˚, 40˚, or 20˚ scan.
6) If desired, readjust the Bearing Line as discussed previously to change the center of the Sector Scan.
7) Press the BRG Softkey again to remove the Bearing Line and cursor. The bearing reference is reset to 0º.
366
Figure 6-111 Selecting Sector Scan Position
Garmin G1000 Pilot's Guide for the Diamond DA62
190-00-01895-00 Rev. A