Garmin G1000 Diamond DA62 Pilot's Manual page 590

APPENDIX A
Message Advisory
GPS NAV LOST – Loss of GPS
navigation. Insufficient satellites.
GPS NAV LOST – Loss of GPS
navigation. Position error.
GPS NAV LOST – Loss of GPS
navigation. GPS fail.
ABORT APR – Loss of GPS navigation.
Abort approach.
APR DWNGRADE – Approach
downgraded.
TRUE APR – True north approach.
Change HDG reference to TRUE.
GPS1 SERVICE – GPS1 needs service.
Return unit for repair.
GPS2 SERVICE – GPS2 needs service.
Return unit for repair.
NAV1 SERVICE – NAV1 needs service.
Return unit for repair.
NAV2 SERVICE – NAV2 needs service.
Return unit for repair.
NAV1 RMT XFR – NAV1 remote
transfer key is stuck.
NAV2 RMT XFR – NAV2 remote
transfer key is stuck.
G/S1 FAIL – G/S1 is inoperative.
G/S2 FAIL – G/S2 is inoperative.
G/S1 SERVICE – G/S1 needs service.
Return unit for repair.
G/S2 SERVICE – G/S2 needs service.
Return unit for repair.
GRS 77 ATTITUDE AND HEADING REFERENCE SYSTEM
Message Advisory
AHRS1 TAS – AHRS1 not receiving
airspeed.
AHRS1 GPS – AHRS1 using backup
GPS source.
AHRS1 GPS – AHRS1 not receiving
any GPS information.
AHRS1 GPS – AHRS1 not receiving
backup GPS information.
576
Comments
Loss of GPS navigation due to insufficient satellites.
Loss of GPS navigation due to position error.
Loss of GPS navigation due to GPS failure.
Abort approach due to loss of GPS navigation.
Use LNAV minima when approach is downgraded.
Displayed after passing the first waypoint of a true north approach when the nav
angle is set to 'MAGNETIC'.
A failure has been detected in the GPS1 and/or GPS2 receiver. The receiver may still
be available. The G1000 system should be serviced.
A failure has been detected in the NAV1 and/or NAV2 receiver. The receiver may still
be available. The G1000 system should be serviced.
The remote NAV1 and/or NAV2 transfer switch is stuck in the enabled (or "pressed")
state. Press the transfer switch again to cycle its operation. If the problem persists,
the G1000 system should be serviced.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The G1000
system should be serviced.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The receiver
may still be available. The G1000 system should be serviced when possible.
Comments
The #1 AHRS is not receiving true airspeed from the air data computer. The AHRS
relies on GPS information to augment the lack of airspeed. The G1000 system should
be serviced.
The #1 AHRS is using the backup GPS path. Primary GPS path has failed. The G1000
system should be serviced when possible.
The #1 AHRS is not receiving any or any useful GPS information. Check AFMS
limitations. The G1000 system should be serviced.
The #1 AHRS is not receiving backup GPS information. The G1000 system should be
serviced.
Garmin G1000 Pilot's Guide for the Diamond DA62 190-01895-00 Rev. A