Table of Contents
Advertisement
APPENDIX B
An indication of 'Complete' still requires a power cycle before the synchronized databases will be used by
the system.
The Display Database Softkey (Figure B-8) is used to place the cursor in the Database Window. Upon
first press of the Display Database Softkey, the softkey will change to a selected state (black text on gray
background) and the cursor will appear in the Database Window. At this point the user can scroll through
all databases in the Database Window to view status information. If the Display Database Softkey is pressed
repeatedly, the softkey will switch between PFD1 and MFD1. Database status information in the Database
Window will reflect the database of the selected PFD or MFD. After a successful sync and restart, verify that
the proper databases are now in use on the AUX–System Status Page (Figure B-5).
If an error occurs during the synchronization, an error message will be displayed, followed by the affected
display in the Sync Status section of the Database Window (Figure B-6). If a synchronization completes on
one display, but an error occurs on another, the error message will be displayed with the affected diaplay
listed after it. When an error message (Table B-1) is displayed, the problem must be corrected before the
synchronization can be completed. A power cycle is required to restart synchronization when 'Card Full' or
'Err' is shown.
588
Figure B-5 AUX-System Status Page, Database Window
Figure B-6 Synchronization Error Message
Garmin G1000 Pilot's Guide for the Diamond DA62
Database
Synchronization
Error Message
190-01895-00 Rev. A
Advertisement
Table of Contents
Troubleshooting
