Garmin G1000 Diamond DA62 Pilot's Manual page 481

D
escent anD
Pathways are shown descending only for a programmed descent (Figures 8-5, 8-6). When the flight plan
includes programmed descent segments, pathways are displayed along the descent path provided that the
selected altitude is lower than the programmed altitude.
When an approach providing vertical guidance is activated, Pathways are shown level at the selected
altitude or at the next programmed crossing altitude, Pathways are shown level at the selected altitude or
at the next programmed crossing altitude, whichever is higher, up to the point along the final approach
course where the altitude intercepts the extended vertical descent path, glidepath, or glideslope. From
the vertical path descent, glidepath, or glideslope intercept point, the pathways are shown inbound to the
Missed Approach Point (MAP) along the published lateral and vertical descent path.
During an ILS approach, the initial approach segment is displayed in magenta at the segment altitudes
if GPS is selected as the navigation source on the CDI. When switching to localizer inbound with LOC
selected as the navigation source on the CDI, pathways are displayed in green along the localizer and glide
slope.
VOR, LOC BC, and ADF approach segments that are approved to be flown using GPS are displayed in
magenta boxes. Segments that are flown using other than GPS or ILS, such as heading legs or VOR final
approach courses are not displayed.
Selected Altitude
set for Departure
190-01895-00 Rev. A
a
PPRoach
Selected Altitude
set for Enroute
Climbs NOT
displayed
by pathway
Figure 8-5 SVT Pathways, Enroute and Descent
Garmin G1000 Pilot's Guide for the Diamond DA62
Non-programmed descents NOT displayed by pathway
TOD
Selected Altitude
for Step Down
Selected Altitude or Programmed Altitude
(whichever is higher)
ADDITIONAL FEATURES
Programmed descent
displayed by pathway
467