Garmin G1000 Diamond DA62 Pilot's Manual page 36

SYSTEM OVERVIEW
(optional)
SYN VIS
PATHWAY SYN TERR HRZN HDG APTSIGNS
• XPDR Displays transponder mode selection softkeys:
Selects standby mode (Transponder does not reply to any interrogations)
STBY
ON Selects Mode A (Transponder replies to interrogations)
ALT Selects Mode C – altitude reporting mode (Transponder replies to identification and altitude
GND Manually selects Ground Mode (Transponder does not allow Mode A and Mode C
VFR Automatically enters the VFR code (1200 in U.S.A. only)
CODE Displays transponder code selection softkeys 0-7
0 — 7 Use numbers to enter code
IDENT Activates the Special Position Identification (SPI) pulse for 18 seconds, identifying the
BKSP Removes numbers entered, one at a time
ADS-B TX Enables/disables automatic transmission of ADS-B position and speed. (optional)
• IDENT Activates the Special Position Identification (SPI) pulse for 18 seconds, identifying the
• TMR/REF Displays/removes Timer/References Window
22
PFD
(optional)
DFLTS WIND DME BRG1
OPTN1 OPTN2 OPTN3
Figure 1-18 PFD Configuration Softkeys
interrogations)
replies, but does permit acquisition squitter and replies to discretely addressed Mode S
interrogations)
transponder return on the ATC screen
transponder return on the ATC screen
Garmin G1000 Pilot's Guide for the Diamond DA62
HSI FMT BRG2 ALT UNIT
Press the BRG1/BRG2 Press the STD BARO or BACK
softkeys to display/remove Softkey to return to the top-level
the Bearing Information softkeys.
windows and cycle through
bearing sources:
- NAV1/NAV2
- GPS
- ADF
OFF
360 HSI ARC HSI
METERS IN HPA
STD BARO BACK ALERTS
BACK ALERTS
BACK ALERTS
BACK ALERTS
BACK ALERTS
190-01895-00 Rev. A