Garmin G1000 Diamond DA62 Pilot's Manual page 593

GRA 5500 MESSAGE ADVISORIES
Message
GRA1 CONFIG – GRA1 config error.
Config service req'd.
GRA1 SERVICE – GRA1 needs service.
Return unit for repair
GRA1 CAL – GRA1 calibration. Service
req'd.
GRA1 TEMP – GRA1 over
temperature.
GRA1 MANIFEST – GRA1 software
mismatch, communication halted.
MISCELLANEOUS
Message Advisory
FPL WPT LOCK – Flight plan waypoint
is locked.
FPL WPT MOVE – Flight plan
waypoint moved.
TIMER EXPIRD – Timer has expired.
DB CHANGE – Database changed.
Verify user modified procedures.
DB CHANGE – Database changed.
Verify stored airways.
FPL TRUNC – Flight plan has been
truncated.
LOCKED FPL – Cannot navigate
locked flight plan.
WPT ARRIVAL – Arriving at waypoint
-[xxxx]
STEEP TURN – Steep turn ahead.
INSIDE ARSPC – Inside airspace.
ARSPC AHEAD – Airspace ahead less
than 10 minutes.
190-01895-00 Rev. A
Comments
The GRA and GDU have incompatible configurations.
The GRA self-test has detected a problem in the unit. The system should be serviced.
GRA1 has improper calibration. The system should be serviced.
The system has detected an over temperature condition in GRA1.
The GRA has incorrect software installed. The system should be serviced.
Comments
Upon power-up, the G1000 system detects that a stored flight plan waypoint is
locked. This occurs when an navigation database update eliminates an obsolete
waypoint. The flight plan cannot find the specified waypoint and flags this message.
This can also occur with user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any database,
OR
update the waypoint name/identifier to reflect the new information.
The system has detected that a waypoint coordinate has changed due to a new
navigation database update. Verify that stored flight plans contain correct waypoint
locations.
The system notifies the pilot that the timer has expired.
This occurs when a stored flight plan contains procedures that have been manually
edited. This alert is issued only after an navigation database update. Verify that the
user-modified procedures in stored flight plans are correct and up to date.
This occurs when a stored flight plan contains an airway that is no longer consistent
with the navigation database. This alert is issued only after an navigation database
update. Verify use of airways in stored flight plans and reload airways as needed.
This occurs when a newly installed navigation database eliminates an obsolete
approach or arrival used by a stored flight plan. The obsolete procedure is removed
from the flight plan. Update flight plan with current arrival or approach.
This occurs when the pilot attempts to activate a stored flight plan that contains
locked waypoint. Remove locked waypoint from flight plan. Update flight plan with
current waypoint.
Arriving at waypoint [xxxx], where [xxxx] is the waypoint name.
A steep turn is 15 seconds ahead. Prepare to turn.
The aircraft is inside the airspace.
Special use airspace is ahead of aircraft. The aircraft will penetrate the airspace within
10 minutes.
Garmin G1000 Pilot's Guide for the Diamond DA62
APPENDIX A
579