Garmin G1000 Diamond DA62 Pilot's Manual page 107

COM3 – Not used in DA62 aircraft.
6
COM 1/2 – Split COM Key. Allows simultaneous transmission on COM1 and COM2 by the pilot and copilot.
7
TEL – When selected, audio from the satellite telephone can be heard (optional).
8
PA – Not used in DA62 aircraft.
9
SPKR – Not used in Diamond DA62 aircraft.
10
MKR/MUTE – Selects marker beacon receiver audio. Mutes the currently received marker beacon receiver
11
audio. Unmutes automatically when new marker beacon audio is received. Also, stops play of recorded
COM audio.
HI SENS – Press to increase marker beacon receiver sensitivity. Press again to return to low sensitivity.
12
DME – Turns optional DME audio on or off.
13
NAV1 – When selected, audio from the #1 NAV receiver can be heard.
14
ADF – Turns optional ADF receiver audio on or off.
15
NAV2 – When selected, audio from the #2 NAV receiver can be heard.
16
AUX – Not used in DA62 aircraft.
17
MAN SQ – Enables manual squelch for the intercom. When the intercom is active, press the PILOT Knob
18
to illuminate SQ. Turn the PILOT/PASS Knobs to adjust squelch.
PLAY – Press once to play the last recorded COM audio. Press again while audio is playing and the
19
previous block of recorded audio is played. Each subsequent press plays each previously recorded block.
Pressing the MKR/MUTE Key during play of a memory block stops play.
PILOT – Selects and deselects the pilot intercom isolation.
20
COPLT – Selects and deselects the copilot intercom isolation.
21
PILOT Knob – Press to switch between volume and squelch control as indicated by illumination of VOL
22
or SQ. Turn to adjust intercom volume or squelch. The MAN SQ Key must be selected to allow squelch
adjustment.
PASS Knob – Turn to adjust Copilot/Passenger intercom volume or squelch. The MAN SQ Key must be
23
selected to allow squelch adjustment.
DISPLAY BACKUP Button – Manually selects Reversionary Mode.
24
190-01895-00 Rev. A
Garmin G1000 Pilot's Guide for the Diamond DA62
AUDIO PANEL AND CNS
93