Garmin G1000 Diamond DA62 Pilot's Manual page 604

APPENDIX B
5) Acknowledge the Power-up Page agreement by pressing the ENT Key or the right most softkey.
6) Turn the large FMS Knob to select the AUX Page group on the MFD.
7) Turn the small FMS Knob to select the System Status Page.
8) Monitor the Sync Status in the Database Window. Wait for all databases to complete synchonization, indicated
by 'Complete' being displayed as seen in Figure B-6.
9) Remove and reapply power to the system.
10) Turn the large FMS Knob to select the AUX Page group on the MFD.
11) Turn the small FMS Knob to select the System Status Page.
12) Press the Display Database Selection Softkey to show database information for each display (MFD1 DB, PFD1
DB). Verify the correct database cycle information is shown for each database for each display.
MAGNETIC FIELD VARIATION DATABASE UPDATE
A copy of the current magnetic field variation database (MV DB) is included with the navigation database.
At startup, the system compares this version of the MV DB with that presently being used by the AHRS (GRS).
If the system determines the MV DB needs to be updated, a prompt is displayed on the Navigation Map Page.
590
Figure B-7 Database Information on the Power-up Screen
Unselected MFD1 DB Selected PFD1 DB Selected
Figure B-8 Display Database Softkey
Garmin G1000 Pilot's Guide for the Diamond DA62 190-01895-00 Rev. A