Garmin G1000 Diamond DA62 Pilot's Manual page 80

FLIGHT INSTRUMENTS
GPS
Selected
Extended
Course
Line
Enabling/disabling OBS Mode while navigating a GPS flight plan:
1) Press the OBS Softkey to select OBS Mode.
2) Turn the CRS Knob to select the desired course to/from the waypoint. Press the CRS Knob to synchronize the
Selected Course with the bearing to the next waypoint.
3) Press the OBS Softkey again to return to automatic waypoint sequencing.
As the aircraft crosses the missed approach point (MAP), automatic approach waypoint sequencing is
suspended. SUSP appears on the HSI at the lower right of the aircraft symbol. The OBS Softkey label
changes to indicate the suspension is active as shown in Figure 2-30. Pressing the SUSP Softkey deactivates
the suspension and resumes automatic sequencing of approach waypoints.
66
OBS Mode
Enabled
Pressing the OBS
Softkey Enables
OBS Mode
Figure 2-29 Omni-bearing Selector (OBS) Mode
SUSP
Softkey
Figure 2-30 Suspending Automatic Waypoint Sequencing
Garmin G1000 Pilot's Guide for the Diamond DA62
Pressing the OBS
Softkey Again
Disables OBS Mode
SUSP
Annunciation
190-01895-00 Rev. A