Table of Contents
Advertisement
HAZARD AVOIDANCE
Vertically scanning a storm cell:
Vertical scanning of a storm cell should be done with the aircraft wings level to avoid constant
NOTE:
adjustment of the Bearing Line.
1) While in the Horizontal Scan view, press the BRG Softkey. This places the cursor in the BEARING field and
displays the Bearing Line.
If the Bearing Line is not displayed, press the MENU Key and turn the large FMS Knob to select Show Bearing
Line. Press the ENT Key.
2) Press the ENT Key.
3) Turn the small FMS Knob to place the Bearing Line on the desired storm cell or other area to be vertically
scanned.
Bearing Line
4) Press the VERTICAL Softkey. A vertical scan of the selected area is displayed (Figure 6-108).
5) The small FMS Knob may be used to move the scanned bearing line a few degrees right or left.
6) Turn the Joystick to adjust the range.
7) Press the FMS Knob to remove the cursor.
8) To select a new area to be vertically scanned, press the HORIZON Softkey to return to the Horizontal Scan view
and repeat the previous steps.
The Joystick can also be used to adjust bearing from left to right.
362
Figure 6-107 Bearing Line on Horizontal Scan
Garmin G1000 Pilot's Guide for the Diamond DA62
Scan Line
190-00-01895-00 Rev. A
Advertisement
Table of Contents
Troubleshooting
