Toyota VELLFIRE 2010 Manual page 424

Machine Translated by Google
422 5-4. How to use other interior equipment
ÿ When it cannot be used If
the operation indicator lamp of the main switch goes out and AC power is not output from the outlet, and if
the main switch is turned ON again and the power does not recover, it is possible that the protective function
has been activated. You can In this case, please take the following steps first. •Unplug the electrical
product, check if the power consumption is 1500W or less, and turn on the main switch again.
• Unplug the electrical product, check that the product itself is not damaged, and turn on the main switch
again.
•Check the remaining power of the drive battery (ÿ P. 100). If the remaining power is low, move the shift lever
to P to restore the drive battery's remaining power, then turn the main switch back on.
If the inside of the car is hot, such as immediately after leaving it in the hot sun, use the air conditioner to
ventilate the inside of the car sufficiently, lower the temperature inside the car, and turn the main switch
back on after a while. .
If the problem persists even after taking the above measures, have the vehicle inspected by your Toyota
dealer.
ÿ When using in cold climates
When the outside temperature drops below -15°C, the accessory outlet may not be used for several tens of
minutes to protect the drive battery. In this case, use the air conditioner to heat the interior of the vehicle
and warm the drive battery before using the vehicle.
ÿ Power frequency
The power frequency on the vehicle side is set to 50Hz. Some
electrical products have a power frequency switching function (50Hz/60Hz), so match the power frequency
between the vehicle and the electrical product. If you need to switch the power supply
frequency on the vehicle side, please consult your Toyota dealer.