Toyota VELLFIRE 2010 Manual page 150

Machine Translated by Google
148 3-2. How to open/close and lock the door
ÿ Warning sounds and warning displays
To prevent unexpected accidents or theft due to erroneous operation, a warning tone may sound
or a warning may be displayed on the multi-information display. When a warning
is displayed, take appropriate measures based on the indications on the display. (ÿ P. 500) The
following are the
situations and countermeasures when only the warning tone sounds.
A "beep" sounds from outside the
vehicle for 5 seconds
Continuous "beep, beep" sounds
from inside the car
ÿ "Smart Entry & Start System" on the multi-information display
System failure Check manual" is displayed
There may be an abnormality in the system. Have it checked by a Toyota dealer immediately.
ÿ Power saving function
The power saving function works to prevent the electronic key battery and the auxiliary battery of the vehicle from running out when the vehicle
is parked for a long period of time.
•In the following situations, it may take time for the smart entry and start system to unlock.
It may cost.
ÿ Leaving the electronic key within 2m outside the vehicle for
more than 10 minutes ÿ Not using the smart entry & start system for more than 5 days
• If the smart entry & start system has not been used for more than 14 days, other than the driver's
seat You will not be able to unlock with . In this case, grasp the door handle of the driver's seat,
or unlock it with the wireless function or mechanical key.
alarm
Attempting to lock with the
Smart Entry & Start System
or wireless function while
one of the doors is open
The power switch was set to
accessory mode while the
driver's door was open (the
driver's door was opened
while in accessory mode).
situation
After closing all the doors,
lock them again.
After turning off the power
switch, close the driver's door.
Workaround