Toyota VELLFIRE 2010 Manual page 286

Machine Translated by Google
284 4-5. Driving Support Device
knowledge
ÿ Operating conditions
• Front corner sensor:
ÿ When the power switch is in ON mode ÿ When
the shift lever is in a position other than P ÿ
When the vehicle speed is approximately 10 km/h or less (except when the shift lever is in R*)
*
Excluding vehicles equipped with Intelligent Clearance Sonar
•Front side sensorÿ/Rear side sensorÿ:
ÿ When the power switch is in ON mode ÿ When the
shift lever is in any position other than P ÿ When
the vehicle speed is about 10 km/h or less ÿ
When the steering wheel is turned more than about 90 degrees
•Front sensorÿ:
ÿ When the power switch is in ON mode ÿ When the
shift lever is in a position other than P or R ÿ When the
vehicle speed is approximately 10 km/h or less
-Rear corner sensor:
ÿ When the power switch is in the ON mode
ÿ When the shift lever is in R ÿ When
the vehicle speed is about 10 km/h or less (when intelligent clearance sonar is installed)
car) Back sensor:
ÿ When the power switch is in the ON mode
ÿ When the shift lever is in the R
position ÿRegarding clearance sonar interrupt displayÿ
ÿ P.308
ÿSensor Sensing •The sensing
range of the sensor is limited to the front and rear bumpers of the vehicle. Depending on the
shape and conditions of the obstacle, the range that can be sensed may be shortened, or it may not be sensed.
You may.
• If the sensor is too close to an obstacle, it may not detect it. •It takes some time
for the display and buzzer to sound after detecting an obstacle. Even when traveling at low
speeds, the vehicle may come within about 35 cm of the obstacle before the display or buzzer
sounds.
ÿ: Equipment may or may not be available depending on the grade and options.