Toyota VELLFIRE 2010 Manual page 248

Machine Translated by Google
246 4-3. How to turn on the lamp and how to use the wiper
knowledge
ÿ Operating conditions
When the power switch is in ON mode
ÿAbout automatic high beam
•In the following situations, the high beam may not automatically switch to the low beam.
vinegar.
ÿ When suddenly passing an oncoming vehicle on a curve
with poor visibility ÿ When
another vehicle crosses the road ahead
When
•High beams may switch to low beams due to the fog lights of oncoming vehicles.
I will.
•Street lights, traffic lights, advertising lighting, signs, billboards, and other reflective objects
may cause high beams to switch to low beams, or low beams to continue. • The timing
of switching between high beam and low beam changes due to the following reasons.
There are cases.
ÿ Brightness of the lamps of the oncoming or preceding vehicle
ÿ Movement and direction of the oncoming or preceding
vehicle ÿ When only one side of the oncoming or preceding vehicle is lit ÿ When the oncoming
or preceding vehicle is a two-wheeled vehicle ÿ Road
conditions Conditions (slopes, curves, road conditions, etc.) Number
of passengers and amount of luggage
• The automatic high beam recognizes the surrounding situation from the brightness of the
lamps in front of the vehicle. Therefore, high beams and low beams may switch
inconsistently with the driver's senses.
• Light vehicles such as bicycles may not be detected.