Toyota VELLFIRE 2010 Manual page 289

Machine Translated by Google
when retreating
Multi-information
display display
Vehicle condition*
: Sensing area of the side sensor
: Side area (area where side area scanning has not been completed) :
Side area (area where side area scanning has been completed)
*
The illustration is an example for explanation and differs from the actual sensing area.
ÿWhen "Please clean the sonar" is displayed on the multi-information display Ice, snow, mud, etc. may
be attached to the
clearance sonar sensor. In this case, if you remove ice, snow, mud, etc. from the sensor, it will
return
to normal. Also, when the temperature is low, the sensor may freeze, resulting in an
abnormal display or an obstacle that may not be detected. When the ice melts, it will return to
normal.
ÿ "Clearance sonar failure" is displayed on the multi-information display.
when you get
The device may not operate normally due to a sensor abnormality. Have it checked at a Toyota
dealer.
ÿ Customization function
You can change the volume of the buzzer,
etc. (Customization list: ÿ P. 561)
Scanning of
the side area is
incomplete
power switch
Immediately after switching to ON mode
4-5. Driving support equipment
Completed scanning
of the rear
half of the vehicle
The state in which the distance of half of
the total length of the vehicle is reversed
287
Side area scanning
completed
The state in which the distance of the full
length of the car body is reversed
4 driving