Toyota VELLFIRE 2010 Manual page 270

Machine Translated by Google
268 4-5. Driving support equipment
change the set speed
To change the set speed, operate the lever until the desired speed is displayed.
Increase speed
1
(except during controlled stop in vehicle distance
control
mode) Decrease speed
2
Fine adjustment: Lightly operate the lever up or
down and let go
Large adjustment: hold the lever until the desired
speed is reached
In vehicle-to-vehicle control mode, the set speed is increased or decreased as follows:
Fine adjustment: about 1km/h per lever operation
Large adjustment: approximately 5 km/h every 0.75 seconds while holding the lever
In constant speed control mode (ÿ P. 271) the set speed is increased or decreased as follows:
Fine adjustment: about 1km/h per lever operation
Large adjustment: while holding the lever
Changing the distance between vehicles (Vehicle distance control mode)
Each time you press the switch, the distance between
vehicles changes as follows.
long
1
2
medium short
3
The following distance
time the power switch is turned to ON
mode .
If there is a preceding vehicle, the preceding vehicle mark will also be displayed.
is restored each
1
1
2
Leading
vehicle mark